12V ON OFF SWITCH WITH FLASH LED LIGHTING WIRELESS REMOTE CONTROL RM1000

Description

RM1000
Turn your 12Vdc LED lights on and off with flash. This kit is especially designed for use with 12v LED lighting device, it has 4 different flash modes to choice from, modes are preset by the factory and there is not necessary to make any adjustment, with built-in programmed integrated circuit, it will memorized your last timer mode when the device is turn back on.
Flash mode: 0.25sec, 0.5sec, 1sec, and steady "ON"
Toggle remote button each time to switch between mode, press off to turn off operation
What's in the kit:
-Package included: 1 receiver + 1 remote controller (battery included)
-Dimensions on receiver box: 2 1/8" x 2 1/4" x 1 1/4" (8cm x 5.5cm x 3.5cm)
-Operating voltage: 12Vdc (do not exceed 15Vdc to avoid overload)
-Remote control operating range: 0~22ft (tested in open area, range may vary depend on area)
-Remote control bandwidth: 315Mhz
- 2 buttons remote control: {f} for toggle between modes, {off} for shut down power.
-Built-in LED timing mode indicator on receiver box for easy navigating  lighting control
-Memorize your last setting on next power up (reset if main power is cut off)
Wiring:
-Red wire: positive power input (use 12vdc only, do not overload)
-Black wire: ground/negative power input
-Green wire: Antenna (caution: make sure it does not touch any power source to prevent short to receiver)
-Yellow wire: connect to lighting device positive
-Blue wire: connect to lighting device negative/ground
-Do not connect directly to any 120/240VAC power without using a 12V AC/DC converter or adapter.